Axis 7100 Installationsanleitung PDF herunterladen (Seite 184)

Workpiece Alignment

Advanced Dicing Technologies Ltd.

6.1-22

6.1.4.1 Multi-Panel Bar Code Identification

The new option “Choice of cutting angle by panel” can synchronize

with bar code reading ability to enable naming each of the panels according

to the bar code identified with it. The panel name will be displayed on the

animated cut map.

6.1.4.2 Teach Alignment Multi-Panel Adaptations

To adjust the Teach Alignment procedure in an existing recipe for a multi-

panel application, conduct the following steps:

1 Add new angles to recipe, see Figure 6-17.

2 Define the number of panels (1 to 4).

3 Set the parameter values for each panel (angles, idx, etc.).

4 Follow the instructions of the Teach Align Wizard, similar to the

standard Multi-Panel Teach Align process, only with Cut Position

definition for the specific angles for the different panels.

6.1.5 Model Types

The 7100 Dicing Series machines use two major types of alignment models:

• Die Model, see section 6.1.5.1

• Align Kerf Model, see section 6.1.5.2

The model option can be selected from the drop-down menu to the right

from the Video Workspace, as shown in

Figure 6-19.

6.1.5.1 Die Model

The Die models are the models used for the traditional alignment based on

having the System remember two eye-points on the workpiece. These two

points define the baseline for adjusting the parallelism of the kerfs. Once

the Workpiece has been aligned, the alignment is taught to the System.

Afterwards, the System automatically updates (straightens) the substrate

position on the Cutting Chuck by turning the Theta Axis.

The Die Models can be used as Main, Low or Sub-models. Before teaching

alignment, add all the categories and parameters for each angle in the

recipe, save the recipe, and then teach the alignment.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 423 424

Keine Kommentare

Axis 7100 Installationsanleitung Seite 184