Axis AXIS USB Bedienerhandbuch PDF herunterladen (Seite 27)

FW is the firmware version and SN is the hardware serial number.

Relay Output Config (Original/B Type)

Operate Mach3 main menu’s “Config”->”Ports and Pins”. Then click on “Output

Signals” page. Click to put green tick on “Enabled” column of the “Output #1”

and “Output #2” row. Their “Port #”, “Pin Number” and “Active Low” should be

set according to physical connection(referring to chapter “Shape and

Connections”, section “Relay Outputs”), put a green tick on “Active Low” if the

output is effective when low. “Output #1” and “Output #2” can be further

mapped further to control mist, coolant and spindle motor etc.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 67 68

Keine Kommentare

Axis AXIS USB Bedienerhandbuch Seite 27