Axis P5534 Installationsanleitung PDF herunterladen (Seite 10)

Page 10 AXIS P5532/P5534 Installation Guide

14. Place the trim ring over the ceiling bracket and snap it into place.

Bracket mount (optional accessory)

1. Install the selected bracket according to the

instructions supplied with the bracket. If drilling is

required, make sure to use drill bits, screws, and

plugs that are appropriate for the material.

2. Loosen the 4 camera base lid screws and remove

the camera base lid, see illustration on page 5.

3. Route the network cable and the multi-connector

cable, if applicable, through the holes in the

mounting bracket.

4. Hook the camera to the safety wire on the bracket.

5. Connect the network cable and, if applicable, the

multi-connector cable to the network camera.

6. Install AXIS T8123, see Install the AXIS T8123 High PoE Midspan 1-port, on page 11.

7. Put the camera base lid back in its original position.

8. Slide the unit holders on the network camera into the slots on the bracket and rotate the

camera unit.

9. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).

Trim ring

Wall bracket (mounting example)

Safety

wire

Slots for

Screws

Torx T30

unit holders

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 111 112

Keine Kommentare

Axis P5534 Installationsanleitung Seite 10