Axis P5522-E Bedienungsanleitung PDF herunterladen (Seite 47)

AXIS P5522 PTZ Dome Network Camera

Multi-Connector Cable (sold separately)

When connecting external equipment to the Axis product, a multi-connector cable (available from Ax is) is req u ire d in order to

maintain the product’s IP rating. The multi-connector cable can be purchased from your Axis reseller.

Connect the multi-connector cable to the product’s multi-connector (see page 4 ). The c able provides the following connectors:

Note

See page 53 for technical speciﬁcations.

Power connector - 3-pin terminal block used for power input. See image below.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker

with a built-in ampliﬁer. A pair of head phones can also be attached. A stereo connector must be used for the audio out.

I/O terminal connector - Use in applications for e.g. motion detection, event triggering, time lapse recording and alarm notiﬁcations.

In addition to an auxiliary power and a GND pin, the I/O terminal connector provides the interface to:

• Digital output — For connecting external devices such as relays and LEDs. Connected devices can be activated by the

VAPIX® Application Programming Interface, output buttons on the Live View page or by an Event Type. The output will

show as active (shown under Events > Port Status) if the alarm device is activated.

• Digital inp ut — An alarm input for connecting devices that can toggle between an open and closed circuit, for example:

PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input

becomes active (shown under Events > Port Status).

Function Pin Notes

Speciﬁcations

GND

Ground

3.3 V DC Power

Can be used to power auxiliary equipment.

Note: This pin can only be used as power out.

Max load = 250 mA

Digital input — Connect to GND to a ctivate, or leave ﬂoating

(unconnected) to deactivate.

0to+40VDCConﬁgurable

(Input or Output)

3–6

Digital output — Internal connection to ground when

activated, ﬂoating (unconnected) when deactivated. If used

with an external relay, a diode m ust be connected in parallel

with the load, for protection against voltage transients.

Max load =100 mA

Max voltage = +40 V DC

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 55 56

Keine Kommentare

Axis P5522-E Bedienungsanleitung Seite 47