Axis RightFax 8.5 Bedienungsanleitung PDF herunterladen (Seite 19)

RightFax 8.5

EN/LZT 108 5826/6 R2B Ericsson



November 2002 15

Assigning Channel Capability to the BoardServers

The Board Configuration screen in the RightFax BoardServer utility lets you configure

the channels (ports) used for fax. Using the Capability box shown in Figure 4 and

Figure 5, you can specify how each channel will be assigned. OneBox can use only the

Dial setting, so that setting must be used for all RightFax BoardServer channels that will

be used for communication between the telephony and fax servers. Setting the

Capability box to Dial allows OneBox to receive and send faxes while allowing the fax

server to use the channel as well. However, due to the nature of analog DID (Direct

Inward Dial) phone circuits, the Capability box for each analog DID channel must be

configured as Answer-Only (Answer).

Important If the fax server includes boards installed on more than one platform, OneBox can

use only the boards installed on the two platforms specified in the OneBox

Configuration utility. In such cases, the following instructions will be applicable

only to the BoardServers on those two platforms.

The type of board you use dictates how you may assign channel capability. For example,

if you use a board such as the Brooktrout TR-114-I4L, which has all loop-start

channels, you may set the channel capability for all channels at the board level as shown

in Figure 4.

Figure 4. Assigning channel capability at the board level

Set to Dial.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Axis RightFax 8.5 Bedienungsanleitung Seite 19