Axis 670e Betriebsanweisung PDF herunterladen (Seite 11)

AXIS 5470e/570/670e User’s Guide AS/400 SNA Printing

10. Type DSPMODD QRMTWSC on the command line to check that the mode description exists

on the system. Press F3. Refer to the AXIS 5470e/570/670e User’s Manual for information

regarding the QRMTWSC mode.

11. Type DSPUSRPRF QUSER. Make sure that the QUSER Status is *ENABLED and has its

Maximum Storage Allowed parameter set to *NOMAX. Press F3.

12. Use the command WRKCFGSTS *CTL xxxx*, where xxxx are the first 4 characters of the

AXIS 5470e/570/670e

LU Name, to delete any previously created Controller and Device

descriptions specific to your AXIS 5470e/570/670e. Delete the Device Descriptions (indented

text) first and then the Controllers. You can print a test page if you are unsure of the AXIS

5470e/570/670e

LU Name.

Configuring the AXIS 5470e/570/670e

Important!

After you have completed the procedures in The AS/400 Host System Checklist on page 10, follow

the instructions below to configure the AXIS 5470e/570/670e for SNA printing in the AS/400

environment using a Web browser:

1. Start a Web browser, e.g. Internet Explorer or Netscape Navigator.

2. Enter the IP address or the host name of the AXIS 5470e/570/670e in the location field and

press the Enter key on your keyboard. The internal Web pages of the AXIS 5470e/570/670e

will appear.

To perform the instructions presented in this section, you should first assign an IP address to your AXIS

5470e/570/670e using one of the methods presented in Assigning an IP address, on page 9. If your network does

not support the TCP/IP protocol suite, you can still configure the AXIS 5470e/570/670e using the AXIS

Netpilot™ installation tool which is available on the AXIS Product CD.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Keine Kommentare

Axis 670e Betriebsanweisung Seite 11