Axis 7100 Betriebsanweisung PDF herunterladen (Seite 11)

AXIS 7100 User’s Guide Basic Installation

Connecting the WORKiO Copier

Caution!

1. Switch off the WORKiO copier and disconnect the AXIS 7100 external power

supply.

2. Connect AXIS 7100 to the WORKiO copier using a fully connected parallel cable.

Connecting the AXIS 7100 to the network

1. Connect your AXIS 7100 to the network. The AXIS 7100 is designed for 10 Mbps

Ethernet and 100 Mbps Fast Ethernet networks and connects to the network via

a twisted pair category 5 cable (10baseT and 100baseTX).

2. Switch on the WORKiO copier.

3. Connect the external power supply to the AXIS 7100. The network indicator will

flash during power up and self test. The following message will appear on the

display during self test (stating the software version number, e.g. 1.00):

Note:

• Check that the power supply included with your AXIS 7100 is marked with the correct voltage.

• Make sure that the external power supply to the AXIS 7100 is disconnected before connecting

and disconnecting to other units.

The tri-colored Network indicator flashes:

• yellow - indicating network activity on a 10MB Ethernet network.

• green - indicating network activity on a 100MB Fast Ethernet network.

• red -indicating that the unit is not correctly connected to the network.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Keine Kommentare

Axis 7100 Betriebsanweisung Seite 11