Axis 241Q Installationsanleitung PDF herunterladen (Seite 7)

AXIS 241Q/S Blade - Rack Solution Installation Guide

Connecting the video server to the rack

Please read through the instructions below before beginning

the installation.

1. Connect the power cable to the power connector on the

rack. Make sure that the green power indicator is lit. See the

illustration for the location of the power indicator.

2. Note the Serial number (S/N) on the front panel on the

video server. You need to know this to set the IP address.

3. Now refer to Installing on a Network in the AXIS 241Q/S

Video Server User’s Manual supplied with the Axis Blade Video

Server, keeping in mind the following details:

•Network - connect the Ethernet cable to the Ethernet

connector on the rack, in the position where the video server

is to be connected.

• Power is supplied via the Bus Connector. Slide the blade video server into the slot. Make sure that the

bus connector is securely connected to the I/O terminal block connector at the back of the rack. When

repeating the installation procedure for each individual blade video server, simply disconnect the blade

video server from the rack (i.e. do not disconnect the power cable).

• Secure the video server to the rack with the PZ1 screws, placing them at the top and bottom of the

front panel. You will need to use a Pozi Drive screwdriver; a regular Philips screwdriver can strip the

screw heads. See the illustration on page 4. The rack accommodates up to 12 individual Axis Video

Servers. To comply with EMC regulations, ensure that all empty slots are covered using the supplied

cover plates.

AXIS 241Q/S Video Server User’s Manual

The functionality of the Axis Blade Video Servers is the same as in the stand-alone versions. For more

information on how to install and configure your video server rack on your network, please refer to the

relevant sections in the AXIS 241Q/S Video Server User’s Manual available in printed format with your AXIS

241Q/S Video Server or on the Axis Web site at www.axis.com

Power

Indicator

1 2 3 4 5 6 7 8

Keine Kommentare

Axis 241Q Installationsanleitung Seite 7